It is currently Fri Oct 24, 2014 9:58 am

How to scale design in S-Edit?

How to scale design in S-Edit?

Postby Tanner_AE_SB » Thu Jun 07, 2012 2:39 pm

Here is the email that I sent to the customer regarding design scale:

Change the locator bar to Internal Units "IU" temporarily so that you can easily find out the scaling factor.

Now open Schematic Grids settings and you will see the value of Snap Grid in internal units (iu).

Let’s say you want to add design A to design B. Open both the designs and note down the snap grids in iu. Open design B and use design scale command.
design scale –numerator SGA –denominator SGB
here, SGA is the Snap Grid of design A in iu
SGB is the Snap Grid of design B in iu

After this change the Schematic Units and then Schematic Grids settings of design B to match with that of design A. You can then press Save to the {project setup folder} to make sure the design stays saved with the new settings.

Now, you can use design B as a library in design A and everything should be on grid.
Tanner_AE_SB
 
Posts: 32
Joined: Thu Jun 07, 2012 2:37 pm

Return to Tips & Tricks

Who is online

Users browsing this forum: No registered users and 1 guest

cron

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 35 on Thu Jan 09, 2014 2:15 am

Users browsing this forum: No registered users and 1 guest

Login Form