It is currently Sun Aug 02, 2015 10:23 am

corner simulations

corner simulations

Postby dfurrer » Tue Feb 28, 2012 12:19 am

How do you perform in T-spice a set of corner simulations over process, voltage and temperature (PVT)? In my mind (ideally), this would be a table format, where each line defines one simulation run. Thanks for any hint.

Re: corner simulations

Postby Guest » Mon Mar 12, 2012 1:55 pm

For corner simulations, you can use the command .alter to your netlist to switch between different corners. You can use .del lib and .lib to unload the old corner and reload the new corner. The following example is copied from the T-Spice user guide.

** Load typical corner
.lib typical

** Load fast corner
.del lib typical
.lib fast

** Load slow corner
.del lib fast
.lib slow

If you have S-Edit, there is a Corner Simulations option in the Setup>SPICE Simulation settings which will give you the table view you are looking for to setup multiple corner simulations.

Return to Schematic capture with S-Edit, Simulation with T-Spice & Waveform viewing/editing with W-Edit

Who is online

Users browsing this forum: No registered users and 1 guest


Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 35 on Thu Jan 09, 2014 2:15 am

Users browsing this forum: No registered users and 1 guest

Login Form