It is currently Tue Sep 02, 2014 8:36 pm

how to simulate the design of tanner tool in other machine

how to simulate the design of tanner tool in other machine

Postby basu » Fri Jul 27, 2012 9:15 pm

Hi,

I have designed a 32 bit ripple carry adder in tanner tool in my personnel computer.
I want to simulate the same design in my laptop.i.e..,I do not want to design again in other machine so how to take the designed file and simulate in another tool.

please tell me the procedure



Thanking you
basu
 

Re: how to simulate the design of tanner tool in other machi

Postby tu2011 » Fri Jul 27, 2012 10:36 pm

To simulate in another tool, you will need to export out from S-Edit a SPICE file. You can do so by going to File > Export > Export SPICE in S-Edit. The exported SPICE file is in H-Spice compatible format. However, you may have some simulation options set that may be T-Spice specific and will need to be manually translated to the equivalent command in your new SPICE simulator.
tu2011
 


Return to Schematic capture with S-Edit, Simulation with T-Spice & Waveform viewing/editing with W-Edit

Who is online

Users browsing this forum: No registered users and 0 guests

cron

Who is online

In total there are 0 users online :: 0 registered, 0 hidden and 0 guests (based on users active over the past 5 minutes)
Most users ever online was 35 on Thu Jan 09, 2014 2:15 am

Users browsing this forum: No registered users and 0 guests

Login Form